德國IFM電感式傳感器，IFT206

IFB3004BBPKG/M/V4A/6m
電感式傳感器
金屬螺紋 M12 x 1
電纜
增長的感應距離

感應距離 4 mm [f]
齊平安裝

電氣設計   DC PNP
輸出功能   常開
  
工作電壓 [V]  10...36 DC
電流負載 [mA]  100
  
短路保護   脈沖
反相保護   是
過載保護   是
電壓降 [V]  < 2.5
  
電流損耗 [mA]  < 10 (24 V)
  
工作距離 [mm]  0...3.25
遲滯 [Sr的百分比]  1...20
開關頻率 [Hz]  800
修正系數   鋼(St37) = 1 / 不銹鋼約0.7 / 黃銅約0.5 / Al約0.4 / Cu約0.3
  
環境溫度 [°C]  0...100
防護等級   IP 68 / IP 69K ), II
EMC電磁兼容   EN 61000-4-2 ESD靜電放電:  4 kV CD / 8 kV AD
EN 61000-4-3 HF radiated電磁場輻射:  10 V/m (80...1000 MHz) 
EN 61000-4-4 Burst暫態脈沖:  2 kV 
EN 61000-4-5脈沖:  0.5 kV (線至線, Ri: 2 Ohm) 
EN 61000-4-6 HF conducted:  10 V (0.15...80 MHz) 
EN 55011:  等級B 
 
MTTF [年]  1669
外殼材料   不銹鋼(316S12); 感應面: PEEK (Polyether-Etherketon)
功能顯示   
開關狀態 LED  黃色
  
接口   PVC電纜 / 6 m; 3 x 0.34 mm2; ? 4.9 mm
  
重量 [kg]  0.256
注釋   ) "COP"
 
配件(同時供貨)   2個固定螺母

德國IFM電感式傳感器，IFT206

 Active Zone / Active face Area over the sensing face in which the sensor reacts to the approach
of the target.
Output function Normally open: Object within the active zone – output switched.
Normally closed: Object within the active zone – output blocked.
Programmable: Choice between normally closed or normally open.
Positive switching: Positive output signal (to L–).
Negative switching: Negative output signal (to L+).
Power-on delay time The time the sensor needs to be ready for operation after application
of the operating voltage (in the millisecond range).
Hysteresis The difference between the switch-on and the switch-off point.
Leakage current Current for the internal supply of 2-wire units, also flows through the
load when the output is unswitched.
Current consumption Current for the internal supply of 3-wire DC units.
Switch point drift The shifting of the switch point owing to changes in the ambient
temperature.
Short circuit protection ifm sensors which are protected against excessive current by means
of a pulsed short-circuit protection. The inrush current of incandescent
lamps, electronic relays and low resistance loads may cause this
protection to cut in and turn the switch off!
Operating voltage The voltage range in which the sensor functions safely. A stabilised
and smoothed direct voltage should be used! Take into account
residual ripple!
Switching frequency Damping with standard target (mild steel) at half nominal sensing
range. The damped – undamped ratio is 1 : 2.
Sensing range
Nominal sensing range sn:
design range of the unit
Real sensing range sr:
individual deviations at room temperature
between 90 % and 110 % of sn
Useful sensing range su:
switch point drift
between 90 % and 110 % of sr
Operating distance sa:
safe switching
between 0 and 81 % of sn

德國IFM電感式傳感器，IFT206

產品留言

標題

聯系人

聯系電話

內容

驗證碼

點擊換一張

注：1.可以使用快捷鍵Alt+S或Ctrl+Enter發送信息!
2.如有必要,請您留下您的詳細聯系方式!